Measure mark and cut the beadboard.
Installing white hardboard wall panel.
In a conventionally framed room with wall studs 16 on center each 4x8 ft.
This is the.
Who says you can t draw on the walls.
The first step in how to install paneling is to remove all wall plates outlets and any nails in the wall.
When installing hardboard on the ceiling secure it firmly to the joists to prevent sagging.
Step 1 move the hardboard panels into the installation room and lean them up against the wall with the backs facing outward toward the room.
Insert 3 4 inch nails through the stud spacing them every 8 inches.
Measure the height of the wall where you plan to install the hardboard panels using a tape measure.
Thrifty white panelboard is 1 8 in.
Use a stud sensor to locate and mark the wall framing.
Using a level mark a plumb line 48 in.
If the corner isn t straight and plumb you ll see gaps.
How to install tempered hardboard panels to walls.
For other options like our thrifty white smooth paneling you can quickly brighten up utility and laundry rooms.
Tack a full panel in place with one long edge aligned with the plumb mark then check to see how the opposite edge fits into the corner.
With our markerboard and frost white panels you can add a functional wall to draw and color on such as in workshops and playrooms.
This will allow it to adjust to the humidity in a room.
Stack the hardboard panels in the room where you plan to install them and leave them for 48 hours to allow them to acclimate.
Gently remove any crown moulding baseboards and trim you plan on using again.
Panel joints may be caulked with pure white silicone sealant and panel edges fitted into extruded plastic moldings.
Thick x 4 ft.
Installation is done using a high grade panel or construction trowel on adhesive.
After attaching the panel to the center stud insert additional nails through all remaining studs in the same manner.
Place the first hardboard panel up to the corner of the wall and locate a wall stud in the center of it.
Panel should end and begin on a stud.
Leave the panels in this location for a minimum of 48 hours before installation to allow them to acclimate.
Plan the installation to start at a left side corner and work outward across the wall to the right.