Installing Sliding Pocket Doors

The weight of solid wood doors can be a challenge to the successful operation of the runner hardware while the hardware will tend to be pulled out from hollow core composite doors.

Installing sliding pocket doors.

The pocket door track is a metal channel with wooden nailing strips on each side. Install door casing nailing it to the jamb and to pocket door studs. Then put the hardware and door into the slider track. All finished to an exceptionally high and stylish standard.

Install the door pulls. Accessories to complete pocket door installations including closing kits door pulls and handles. To install a pocket door start by removing the existing door and the drywall on one side of the wall. Cut through the nailers.

Cavity sliders usa inc is the premier manufacturer of pocket door hardware. Install the pocket door frame measure up from the floor 80 inches leaving anywhere from inches to 1 inches clearance under the door. With strict attention to detail from design through to production cavity sliders offers sliding door products that are high quality reliable and operate smoothly. High quality fully compatible pocket door accessories for use with all our doors and systems.

Complete installation of the johnson pocket door and show how to install a pocket door in los angeles. This is where the frame header brackets will rest. Any door that could be installed as a hung door can be installed as a pocket door. Then cut the exposed studs to make room for the new framing.

If you want to install other hardware be sure that it can be inset into both sides of the door without blocking the door s operation. Next install the slider track using the rails that came in your pocket door kit. Use a stud finder to locate and mark the stud locations then hammer a nail on the center leaving roughly 1 8 inch sticking out. Drill a hole and chisel a shallow mortise in that jamb for the strike plate which the door latch engages.

Install a full width strike jamb on the opposite side. Build your wall to the correct thickness. Be sure to screw the brackets into the studs. Install the pocket door pulls that accompany the framing kit.