Installing Shower Pan And Tile Walls

Screw the shower pan rim into the wall studs using 1 1 4 inch screws through the pre drilled holes.

Installing shower pan and tile walls.

Dry lay the panels and measure them to see where you need to make cuts. If the subfloor is wood it should receive a layer of cement board to protect the wood from the mortar bed under the pan. Place a sheet of cement backer board against the studs starting with one inside corner. Meanwhile install your floor tiles to the wall.

The space between the top of the shower tile and the ceiling is often painted waterproof drywall. How to install tiled shower walls with a prefab base. Installing a shower pan includes many steps such as cementing the floor to create a sturdy base and installing the shower walls. Screw each panel to the studs using 1 1 4 inch cement board drywall screws.

In fact tiled shower walls typically rise about 80 inches above floor level. Place cardboard or another material into the shower pan base to protect its surface. What you really want to do is tile the walls starting with the second row and work up from there. The first row near the floor should be reserved using a ledger or other space saver.

Sometimes the tile rises to meet the ceiling as well. When putting up your shower walls be sure to follow the proper installation procedures to create a watertight seam between the shower pan and wall. Measure your panels of cement backer board to fit the shower walls on each side. Put on mask and ear protection and as needed mark and cut a panel to fit using an angle grinder.

Measure the width of the shower walls on either side of the door. Smooth the cut edge. For the vertical layout begin your pattern at the top of the wall so there ll be full uncut tile at the top. Be sure the backer board sits on top of the lip of the.

And then finish by installing that final row of wall tiles so that it overlaps the floor properly. The standard installation of a tile redi polyurethane shower pan starts with a framed in shower alcove that is sized for the shower pan. Press the shower pan base into the mortar adjusting it until the entire base is level. For tile or shower panels drywall goes in first.

Set the tile panels on the side walls with thinset the same way as for the back wall using the starter board. Tiled shower walls receive a significant amount of water but hardly as much water as received by the shower pans. Begin with the length of the shower. Screw the backer board to.

In our project one wall is 31 inches and the other is 36 inches. Mark the locations of all studs along the top edge of the backer board.