Measure the base of the shower doorway so that you can determine the length for the bottom shower door track.
Installing shower door in fiberglass shower.
Place the shower enclosure in place in your bathroom.
Screw in the other side of the door frame image 3.
Place the door track in the middle of the bottom door frame of the shower.
On the side of the shower opening that will support the door hold a jamb piece against the wall so that its lower end fits into the base track.
Stick a pencil through the jamb s screw holes to mark the wall.
Screw one side of the door frame into place on one side of the shower doorway image 1 and then dry fit the other side of the frame image 2 then the top of the frame into place.
Make sure the taller.
Put on your safety glasses.
Put the finishing touch on your shower door installation.
Acrylic shower walls that install by gluing panels to drywall are not an appropriate substrate on which to install any shower door.
Without moving the track use a 4 foot level to adjust the jamb until it s plumb.
Place end caps on the tops of the wall channels.
Drive screws through the pre drilled.
Secure the sides of the door.
Prepare the doors by installing roller and if applicable handle towel bar hardware.
For the frame you ll need to install tracks at the bottom sides and top of your shower opening using sealant and screws.
How to install a door on a fiberglass shower.
Installing the door panels is easiest from outside the shower.
Fiberglass gelcoat is short for gel coat fiberglass reinforced polyester more popularly known as fiberglass.
Place the glass clamp sweep into place on the door s bottom edge and secure it at the door clamp.
The installation process will vary depending on whether you re installing a swinging or sliding glass door but either way you ll need to start by assembling a frame for the door.
Attach the seal strip to the bottom of the door and cut it to the required length.
If you have separate pieces spread construction adhesive on the bottom of the pan and set it in place.
Place the rollers on the top frame flange of both door panels and secure them with lock washers and machine screws.
Hanging the door panels.